HDPLEX passive NUC Kit is designed for H1 Series fanless PC case includes H1 V3 and H1.TODD.

The HDPLEX NUC Kit shares the same six-heatpipe solution as H1 CPU heatsink system. It uses both sides of the H1 fanless PC case to dissipate heat and supports 65W TDP.

HDPLEX passive NUC kit is the best NUC fanless cooling solution on the market and it provides significantly better thermal performance than low cost single aluminum plate direct contact solution.

HDPLEX passive NUC Kit supports two heatsink mounting pattern: Three Point Triangle Mounting which is used by 7th Gen or older NUC and Four Point Square Mounting (35*35mm) which is used by 8th and 10th Gen NUC.

HDPLEX passive NUC Kit comes with two I/O shield plate. One supports HDMI plus single USB Type C 3.1 port layout and the other supports dual HDMI layout. The I/O shield plate has two additional USB port and one 5.5/2.5mm DC jack port to route HDPLEX internal power supply DC output to the backplate.

HDPLEX NUC kit currently supports the following NUC board. Thanks to its modular design, HDPLEX NUC kit will be able to support future NUC by adding new I/O plate.

NUC10i7FNK/FNH
NUC10i5FNK/FNH
NUC10i5FNK/FNH NUC8i7BEB
NUC8i5BEB
NUC8i3BEB
NUC7i7DNBE
NUC7i5DNBE
NUC7i3DNBE
NUC7i7BNB
NUC7i5BNB
NUC7i3BNB

HDPLEX H1 Fanless PC case equipped with HDPLEX Passive NUC kit is the first NUC case on the market to support PCIE expansion card by using M.2 to PCIE riser.

M.2 slot will be occupied by the M.2 to PCIE riser, SATA SSD is required in this configuration.

HDPLEX H1 series with HDPLEX passive NUC kit is also the first NUC case on the market to support internal power supply. You can have a fully internal power supply solution and does not need an external AC adapter if you use HDPLEX internal 80W or 200W AC-DC adapter with 19VDC output.

HDPLEX Passive NUC Kit installation guide could be downloaded here.